Cutler Hammer Contacts

Here are some Culter Hammer upper and lower stationary main contacts attached to a phenolic board along with the movable contacts with studs. These normally arrive with small circular pads as the contact points. We can repair these with full surface pads on the stationary contacts.

GM-7S Stationary Contact

Here is part of a Westinghouse GM-7S Stationary Contact. We repaired a whole set of these along with the movable stabs recently. The contact tips were replaced and all the hardware was cleaned up. The finished assemblies looked and operated as brand new products.

USCO Switch Repair

Below are before and after shots of a USCO HH6 600 AMP switch. We repair these as well as 1200 AMP versions for various customers. If the copper blades are too burned up, we can make new ones and reuse the cast hardware. We also do our own silver plating using 99.9% pure silver.

FPE Finger Cluster

Federal Pacific Finger Cluster. We can resilver and repair your FPE Finger clusters as well as clusters from other OEMs. Be sure to visit our site: wwcomponents.net